rc2hl question
Posted: Tue Aug 27, 2019 2:42 pm
Just getting back into the game. I have an older 1.2 I think rc2hl and I am using it with an hk-t6a. I used this setup previously without any problems, but have messed with the radio settings to work with asp. Now I want to use it for and rx-18 setup. I set the hk radio to the settings you have on a post in the old forum, http://www.rctanksaustralia.com/forum/v ... =149&t=414 ,but the problem is, I cannot get the rx18 to start. I am pretty sure you have said to make it when channel 3 and 4 are at 100%, but I cannot get that to work. I have a red light on the hk receiver, and a green light on the rc2hl. Channel 5 and 6 the pots on the hk-t6a move the attached servos as expected, just can't start the rx18 up.
Can anyone post their t6config or digital radio setup for a 6 channel radio that works with an rc2hl and the rx18?
p.s. I have verified the rx18s are good by adding the old TX board and using the old controller to start.
Thanks for any and all help
Can anyone post their t6config or digital radio setup for a 6 channel radio that works with an rc2hl and the rx18?
p.s. I have verified the rx18s are good by adding the old TX board and using the old controller to start.
Thanks for any and all help