MAKO 2018 Advanced Install Procedure

Post Reply
User avatar
phyrephish
King Tiger Commander
King Tiger Commander
Posts: 135
Joined: Sun Mar 26, 2017 10:24 am

MAKO 2018 Advanced Install Procedure

Post by phyrephish » Sun Aug 26, 2018 7:51 am

Below are some pics to help MAKO2018 users perform the advanced MAKO install. Installation is the same for ALL versions of Heng Long and Taigen MFUs with the exception of the the last step, the microswitch replicator. Heng Long MFUs use the 4th pin as the microswitch input pin where as Taigen MFUs use the 5th pin. Taigen users should also remember to remove the MFU selection jumper.

Image

Image

Image

Image

Image

Image

Image
ImageImageImageImage

Michael
Kübelwagen Driver
Kübelwagen Driver
Posts: 6
Joined: Thu Mar 08, 2018 12:53 am

Re: MAKO 2018 Advanced Install Procedure

Post by Michael » Fri Apr 10, 2020 4:05 pm

Hello,

I tried this modification using a MAKO2018 and a Henglong 2.4Ghz MFU. It did not work for me. I could not get it to shoot at all. I put it back to the way it was before and it shoots again but only after the BB unit spools up. Is there any other modifications I could try to get rid of the delay in shooting?

Thanks

Post Reply