| RC Tanks Australia Forum http://rctanksaustralia.com/forum/ | |
| MAKO2 SMD Cable IS different to previos MAKO http://rctanksaustralia.com/forum/viewtopic.php?f=147&t=861 |
Page 1 of 1 |
| Author: | Phyrephish [ Thu May 22, 2014 12:08 pm ] |
| Post subject: | MAKO2 SMD Cable IS different to previos MAKO |
Hi All Sorry I should of made a bigger note of this earlier but everyone should be aware that there is a change in the cable that connects MAKO2 SMD to the RX18 or Taigen MFU. Previous MAKO cables were all 'Straight Through' the newer MAKO2 SMD uses a "Cross Over" arrangement. makocables.jpg This change was brought about as I found it much easier to obtain and supply the crossover type cable. You can easily change the arrangement of these cables by popping the wires out of one plug, turning the plug over and reinserting the wires. You will know that your MAKO is having a problem because of the different cables if: MAKO powers up and appears fine but does not fire IR. This is because the fire trigger wire and the IR receiver input wires are swapped around. Cheers Kevin G |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ | |